Zanussi is a brand of the Electrolux group, and its electronics are built on the same principle as Electrolux: codes go in groups by system (E1x — water intake, E2x — draining, E4x — door). The Zanussi range includes many front-loading as well as top-loading (narrow, vertical) machines; on top-loading models the module sits in the upper part of the machine, under the control panel.
Codes on models without a display
Zanussi models without a screen report a fault by flashing indicators: a particular indicator flashes a certain number of times, then pauses. The number of flashes is the code number — for example, two flashes correspond to the draining group. Write the number down exactly: it helps to pin down the cause.
Typical faults
- E20 — no draining. Most often the filter; if it is clean, the pump and the triac that controls it.
- E40 — door. The door lock or the circuit that controls it: the module doesn't receive the signal confirming that the lock has closed.
- E10 — no water coming in. The tap, the mesh, the valve and its module output.
- The machine won't turn on. The module's power section or the mains filter.
The full code groups — Electrolux washing machine repair and washing machine error codes.
How we repair
We confirm the code, or the number of indicator flashes, with measurements, replace the faulty component in the module and test the board under load. Electronics repair starts from 80 AZN. Mechanical work (replacing the drum, bearings, drum flaps or pump) is outside our scope. All brands — washing machine repair.