UPS repair and service in Baku

Innova Service has been repairing electronics in Baku since 2008. We repair UPS units (uninterruptible power supplies): offline and line-interactive models for home and office, online (double-conversion) UPS units for servers and equipment, and high-power systems with external battery packs. We work with APC, Eaton, PowerCom, CyberPower, Ippon, Delta, Legrand, Vertiv, Socomec, Tripp Lite, Tescom, Tunçmatik, Makelsan and other brands; UPS troubleshooting starts with measurements of the battery and the inverter.

Repairs start from 50 AZN. We find the cause first, then quote the exact price; work starts only with your approval, and we give a warranty on the work done.

Faults we repair

What happensLikely cause
The UPS shuts off as soon as the power goes outWorn battery, inverter power components — battery replacement
“Replace battery”, red indicator, constant beepingBattery at the end of its life, charging circuit
The UPS won't turn on at allFully discharged battery, fuse, power board
Not charging the batteryCharge controller, its power circuit — inverter and charger repair
“Overload”, shuts off under loadExcessive load, weak battery, inverter, sensor
Switches to battery too often, clicksInput voltage sensitivity, AVR relay, mains supply
Burning smell, humming, heating upInverter transistors, fan, transformer

The battery is the part of a UPS that wears out first

Home and office UPS units use 12-volt lead-acid (AGM) batteries. They usually last 3–5 years, and less in Baku's hot summers and in rooms that get warm. A worn battery is the most common cause of the “won't turn on”, “shuts off at once” and “keeps beeping” symptoms. We replace the battery, check the charging circuit and calibrate the UPS — calibration and load testing.

How we repair

  1. Diagnostics. The batteries, charging circuit, inverter, relay, sensors and board are checked, and the error log is read — service diagnostics.
  2. Price. We tell you in advance, once the faulty part has been found.
  3. Repair. The battery is replaced, the board is restored at component level, and the UPS is cleaned of dust.
  4. Testing. The UPS is run under load: switchover to battery, runtime, charging; we give a warranty on the work.

We do not sell spare parts separately — batteries and other parts are replaced only as part of a repair. About the technician's work — UPS repair technician, prices — UPS repair prices. Inverters for solar and off-grid systems — inverter repair.

Repair or a new UPS: which pays off

The part most often replaced in a UPS is the battery, and replacing it usually costs much less than buying a new unit. For online and high-power UPS units and server equipment, a repair almost always pays off: replacing a burnt transistor, capacitor, relay or fan costs only a small fraction of the price of the whole device. If a small home UPS has both a worn battery and a burnt power board, the repair price may come close to that of a new one — we say so plainly after diagnostics, and the decision is yours.

All major UPS brands

We repair the UPS brands most often found in Baku:

  • APC — the Back-UPS series for home and office and the Smart-UPS series for offices and servers.
  • Eaton — line-interactive and online models, including rack-mount units for server cabinets.
  • PowerCom, CyberPower, Ippon — home and office UPS units for computers, routers and point-of-sale equipment.
  • Delta, Legrand, Vertiv — online UPS units and systems with external battery packs for servers, network and medical equipment.

If your brand is not on the list, that is not a problem: UPS units are built on similar circuits — a power supply, a charging circuit, an inverter and a control board. When you call, tell us the brand and model, and we will tell you in advance where the fault is likely to be and roughly what the repair costs.

How to look after a UPS

  • Temperature. Keep the UPS away from radiators, direct sunlight and closed cabinets: the warmer the room, the faster the battery ages.
  • Load. Do not plug a laser printer, a heater or an electric kettle into the UPS — they cause the “Overload” error and overstress the power components.
  • Self-test. Every few months, run the UPS self-test function or briefly unplug it from the mains and see how it runs on battery.
  • Dust. When the vents and the fan are clogged with dust, the UPS overheats; during a repair we clean the dust out of it.

How to restart a UPS and shut it down properly

  1. Save any open files on the computer and switch off the devices connected to the UPS.
  2. Press and hold the UPS button for a few seconds until it beeps or the indicators go out.
  3. Unplug the UPS from the wall socket; if you will not use it for a long time, the battery can be disconnected too.
  4. To restart, plug the cable back in, wait a minute or two and press the button. If the error remains, do not keep switching the UPS on — it needs diagnostics.

UPS units and voltage stabilizers

Line-interactive UPS units have AVR (automatic voltage regulation): when the voltage drops or rises slightly, the UPS corrects it without switching to battery, so it works like a small stabilizer. Unlike stand-alone voltage stabilizers, though, its range is narrow: if the mains voltage often goes beyond it, the UPS keeps switching to battery, and the relay and the battery wear out quickly. Adjusting the UPS input sensitivity or adding a separate stabilizer in front of it helps here — at diagnostics we look at the error log and tell you which is needed.

UPS batteries

If a UPS cannot hold the load or beeps when the power goes out, the batteries have most likely worn out. Battery replacement is part of a UPS repair: we match the batteries by capacity and voltage and check the charging circuit at the same time, because a faulty charger quickly ruins new batteries. Every uninterruptible power supply repair starts with measurements, so we tell you in advance whether the batteries need replacing or the board is faulty.

Besides the brands above, we repair UPS units from Socomec, Tripp Lite, Makelsan, Tescom, Tunçmatik, EnEl, ElEn and other manufacturers.

Which countries' UPS units we repair

We do not sell UPS units — our work is repairing and servicing them, so the country of manufacture makes no difference to us: their circuits are similar. Troubleshooting a UPS of any brand starts with measurements.

  • USA and Europe. APC and Schneider Electric, Eaton and Powerware, MGE, Vertiv, Legrand, Socomec, Riello, Siel, Masterguard.
  • Türkiye. Inform, Tunçmatik, Makelsan, Tescom, Esis Power, Upset.
  • Asia and other countries. Delta, CyberPower, PowerCom, Must, Astrid, Gamatronic, Mytec, Mercury, Ceres and other brands.

How to choose a UPS: what to look at

  • Type. Standby (offline) for a home computer, line-interactive for an office and mains with voltage swings, online (double conversion) for servers, medical and other sensitive equipment.
  • Power with headroom. Add up the wattage of the devices you will connect and add 20–30%: a UPS running at its limit heats up, and its power components fail sooner.
  • Output waveform. Pumps, boilers and equipment with motors need a pure sine wave; cheaper models with a stepped (simulated) sine wave suit computers only.
  • Run time. It depends on battery capacity. If the load has to be held for a long time, choose a model that takes external battery packs rather than one with a single built-in battery.
  • Ease of repair. Standard-size batteries, access to them without taking the case apart, an error log and a widespread brand make servicing and repair easier.

If the computer itself does not start after a power cut, the fault is usually in its power supply or motherboard — computer repair.

Most UPS failures we see start on the power board — what fails there and how it is repaired is explained in our guide to UPS power board faults.

Besides UPS units, our service center repairs computers, monitors and other devices — electronics repair services.

UPS repair and service in Baku

Get a repair quote

Choose your device and leave your number — we will contact you as soon as possible.

Thank you! Your request is received — we will contact you as soon as possible.

Useful articles

  • Comprehensive UPS Output Channel Testing Service
    UPS Problems

    Comprehensive UPS Output Channel Testing Service

    The reliability of an Uninterruptible Power Supply (UPS) is paramount for ensuring continuous power delivery to critical systems. However, issues with output channels can compromise performance. A dedicated UPS output channel testing service is essential for detecting and resolving these challenges,...

  • Understanding and Preventing UPS Load Control Failure
    UPS Problems

    Understanding and Preventing UPS Load Control Failure

    In the world of uninterruptible power supplies (UPS), load control failure is a critical issue that can disrupt power delivery and lead to significant downtime. This article delves into the causes, consequences, and solutions associated with UPS load control failures, providing you with the insights...

  • Common Causes and Prevention of UPS Output Connector Damage
    UPS Problems

    Common Causes and Prevention of UPS Output Connector Damage

    The reliability of your Uninterruptible Power Supply (UPS) is crucial for safeguarding your sensitive electronic equipment. However, one often overlooked aspect that can compromise its performance is the damage to the UPS output connector. This article delves into the causes, implications, and solut...

  • Understanding Short Power Drops on UPS Output
    UPS Problems

    Understanding Short Power Drops on UPS Output

    In the realm of uninterrupted power supplies (UPS), even a brief interruption can pose significant challenges. Among these disruptions is the issue of a short power drop on UPS output, a problem that can affect the performance of connected equipment. Understanding why these drops occur and how to ad...

  • Understanding and Fixing Weak UPS Output Contacts
    UPS Problems

    Understanding and Fixing Weak UPS Output Contacts

    Weak UPS output contact can be a subtle yet critical issue that affects the efficiency and reliability of your UPS system. When the connection between UPS output contacts falters, it can lead to power delivery disruptions, which poses significant risks for any connected equipment.

  • Why a UPS Cuts Off Connected Devices: Main Causes
    UPS Problems

    Why a UPS Cuts Off Connected Devices: Main Causes

    When a UPS unexpectedly cuts off power to connected devices, it can be both frustrating and costly. Understanding the common causes behind UPS power delivery problems is essential for maintaining continuous and reliable power for critical systems.

Prices

UPS repair and service in Bakufrom 50 AZN
Battery replacementfrom 50 AZN

These are starting prices: we tell you the exact amount after diagnostics.

FAQ

Frequently asked questions

The UPS shuts off as soon as the power goes out. What is the cause?

Most often the battery is worn out. The battery is replaced, the charging circuit is checked and the UPS is calibrated.

My UPS switches to battery too often and clicks. Why?

Possible causes are the input voltage sensitivity, the AVR relay or the mains supply itself. At diagnostics we check the relay and sensors and read the error log.

Do you repair online and high-power UPS units?

Yes, we repair home, office and server UPS units, as well as high-power UPS units with external battery packs.

My UPS won't turn on at all. What is the cause?

Most often the battery is fully discharged; sometimes the fuse or the power board is faulty. The battery is replaced, and the board is restored at component level.

I replaced the battery and the UPS still fails. Why?

Then the cause is not just the battery: the charging circuit, the inverter power transistors, a relay or the control (management) board may be faulty. Sometimes the new battery does not suit the old UPS, the contacts are loose or the UPS has not been calibrated. At diagnostics we check the whole chain under load.

Is repair cheaper than a new UPS?

In most cases, yes: replacing the battery or a few components costs much less than a new UPS, and for online and high-power models the difference is even bigger. We quote the repair price after diagnostics so that you can compare.

How do you replace the battery in a UPS?

The UPS is switched off and unplugged, the old battery is removed, and a new one of the same type, voltage and capacity is connected with the correct polarity. The UPS then fully charges the battery and is calibrated so that it shows the runtime correctly. We replace the battery as part of a repair and check the charging circuit as well.

What does UPS maintenance involve?

Testing the battery under load, cleaning the dust out of the UPS, checking the fan and the contacts, reading the error log and calibration. This catches a fault before the UPS lets you down.

How can I contact you about a UPS repair?

Call the number on the website or message us on WhatsApp: give the UPS model and what is happening — beeping, an indicator, an error. Diagnostics and repairs are carried out at our service center.

UPS units from which countries do you repair?

We do not sell UPS units, we only repair them — devices made anywhere: Europe and the USA (APC, Eaton, Legrand, Socomec, Tripp Lite), Turkey (Makelsan, Tescom, Tuncmatik), Asia (PowerCom, CyberPower, Delta) and other brands.

What are the criteria for choosing a UPS?

Power (VA and W — 20–30% above the total load), type (offline, line-interactive or online; a pure sine wave output for sensitive equipment), battery runtime, the number of outlets and an automatic voltage regulator (AVR). We do not sell UPS units, but we repair yours.

Contacts

Send a request — we will quote the price

Google Maps loads only when you press the button

Get a price

Leave your number — we will contact you as soon as possible.

Thank you! Your request is received — we will contact you as soon as possible.